So, I recently downloaded a few haks (the list of which I won't mention because it is very long), and I saved the module.
All seemed well, until I restarted the toolset, at which point it told me it required these new haks, of which I apperantly did not have in my hak folder.
I looked in my folder and... there were the hak files it was telling me I didn't have.
I imagine this is from some sort of conflict or whatnot... my only interest at this point is -removing- these new haks.
If anyone has any suggestions, they would be most appreiciated.
Hak Issue
Débuté par
Zoey13
, avril 10 2011 08:21
Retour en haut
#2
Posté 10 avril 2011 - 08:55
Shadooow
-
- Members
- 4 470 messages
Open the module in NWHak.exe and export module.ifo
Now open module.ifo in GFF editor, you will see haks in Mod_HakList and you can delete them, after you delete those you want save it and upload via nwhak back to module and save the module.
Now open module.ifo in GFF editor, you will see haks in Mod_HakList and you can delete them, after you delete those you want save it and upload via nwhak back to module and save the module.
#3
Posté 10 avril 2011 - 09:02
Dark Defiance
-
- Members
- 81 messages
Also make sure that you dont have any NWN utilities (like NWN Explorer) open, these seem to lock HAK packs to the point the toolset doesn't see them when you load the module.
-DD
-DD
Modifié par Dark Defiance, 10 avril 2011 - 09:02 .
#4
Posté 11 avril 2011 - 12:15
Zoey13
-
- Members
- 6 messages
Ahh, thank you all so much! This has been fixed, thanks to your help.
#5
Posté 11 avril 2011 - 03:02
Jenna WSI
-
- Members
- 1 078 messages
Dark Defiance wrote...
Also make sure that you dont have any NWN utilities (like NWN Explorer) open, these seem to lock HAK packs to the point the toolset doesn't see them when you load the module.
-DD
I was going to suggest this... happens to me still, I forget and leave stuff open. Close anything except the toolset and nwn.exe and try again.
