7 réponses à ce sujet

[lolkin]

Hey titel says it all is there a way to see what planets you "scanned" etc already?
Or did i just watched over it ?
Thanks in advanced

[Bogsnot1]

Write it down with a pen, on a piece of paper, or remember it.

[lolkin]

Ahh oke well thanks for the response.

[The Grey Ranger]

You could also try using a checklist like this one.

http://masseffect.sh...st2-6_Teryx.pdf

[Wulfram]

I tend to just make a rule of always scanning from the center out.

[kglaser]

Bogsnot1 wrote...

Write it down with a pen, on a piece of paper, or remember it.

I actually had a notebook, and I wrote down each one as I completed it.
If there was something I didn't finish right away for some reason, I put an asterisk next to it, then crossed it off later.
The next time I play, I'll just haul out the notebook and check 'em off again.  I can't stand to leave anything undone.

[EMailakaSrFox]

To answer the question, no there is none, me2 added the % complete on the system, but even that was not enough.

[lolkin]

Thanks for all the response just writing it down and using that pdf thanks all