28 réponses à ce sujet

[Tiberius_Morguhn]

henesua wrote...

Tiberius, square. Something that can cover a section of wall. So it would need to be thick enough to cover the extrusions in some tilesets, and run from floor to ceiling. Wouldn't need to run the full length of a tile. 1meter across would be enough, if it has no frame.Then it could be fit around doors too. Multiple lengths would be ideal.

Jenna, thanks. If these are in CEP, they must be in the Vault, right? I wonder where.... I don't have the patience to dig through CEP to find this.

FYI - my interest in this was to recreate the classic hall of mirrors effect.

I'll see what I can skewer up tonight.  Should be relatively straightforward.  Stay tuned.

[Tiberius_Morguhn]

Mirror wall, both sides mirrored, walkmesh. About half a tiles width and slightly taller than the archways. There is no "thickness" though as its essentially a plane. Is this what you wanted?

[Borden Haelven]

Tiberius_Morguhn wrote...

Tweaked the original and added 6 more......(floor standing and wall mounted)

**Piccies snipped**

These have inspired me to make two add on placeables for use as a mirror based communication system. Watch this space...

[henesua]

Tiberius, thats looking good.

I think it needs thickness though. When you place it against a wall you want the back portion to be able to sink in while the front surface is clear of many of the wall's extrusions.

I wonder what a series of those would look like in sequence, all seamlessly placed to cover the walls of a dungeon corridor....

Thanks!