Whenever I click on Tools - Options I get this error: Access violation at address 004FFBF7 in module "nwtoolset.exe' Read of address 00371EBO.
I used to be able to do this before I installed HUD. I don't know what the fuh is going on. Could someone help me? THanx.
I'm getting an error when I click on Tools - Options.
Débuté par
Groove Widdit
, mai 11 2012 10:32
Retour en haut
#3
Posté 21 mai 2012 - 11:15
_Guile
-
- Members
- 685 messages
A lot of things can cause a read of address error mate...
Your Hard Drive can be faulty... (e.g. data is being written to faulty sectors, use check disk*)
Your RAM could be bad... (Use memtest 4.0 to test your RAM modules)
*Right click on the C: drive and select > Properties, go to the "Tools" tab, and select check for errors..
(This can take A LONG TIME, your computer will need to restart, and make sure you check the box to Fix Bad Sectors)
You should run these checks from time to time to ensure you aren't getting hardware problems..
Hope that helps...
Your Hard Drive can be faulty... (e.g. data is being written to faulty sectors, use check disk*)
Your RAM could be bad... (Use memtest 4.0 to test your RAM modules)
*Right click on the C: drive and select > Properties, go to the "Tools" tab, and select check for errors..
(This can take A LONG TIME, your computer will need to restart, and make sure you check the box to Fix Bad Sectors)
You should run these checks from time to time to ensure you aren't getting hardware problems..
Hope that helps...
Modifié par _Guile, 21 mai 2012 - 11:17 .
